WANTED: 1/4" to 3/16" brake pipe fitting

[rem]

Don't know if this should be here or in the Technical forum, but I need a fitting (a couple, in fact) with 7/16" UNF Female to 3/8" Male threads. This allows the installed 1/4" brake pipe to connect to 3/16" flexy hose at the rear axle. For some reason everyone around here has gone metric, and don't have anything.

[weemark]

andy think ive got the fittings you are after. will get some pics tonight and get them off to you. if its what you need send me your address and I will get them in the post.

EDIT - after reading your post again ive got adapters which have a 7/16 male on one end and a 3/8 female on the other whereas you need the other way - try www.thinkauto.com (http://www.thinkauto.com) or miles at namco, mike at saturn might keep them as well - you do get them because sacramento vintage ford keep them, part no. 12005-15 . also got a couple of spare flexis which have 7/16 ends on them if that helps?

[rem]

Hi Mark, thanks, yes I think I need the opposite to what you have. I think yours would allow the use of 3/16" pipe with early Ford 1/4" brake cylinders, but I have later Ford cylinders with 3/16" fittings on my pickup, but it is plumbed with 1/4" pipe (F-250 with F-100 axles and brakes).

I will probably need some like yours when I eventually get round to changing the '34 brakes, but the truck is the priority for this month at least!

[weemark]

andy had a look through all my fittings and I dont have anything suitable, sorry.